ESP Easy Mega: Collection_B ESP32_ЦЕХ_1


⌂Main⚙Config💬Controllers📌Hardware🔌Devices✉Notifications🔧Tools
×Only one MQTT controller should be active.
Advanced Settings i

Rules Settings

Rules:
Enable Rules Cache:
Tolerant last parameter:
Note: Perform less strict parsing on last argument of some commands (e.g. publish and sendToHttp)
SendToHTTP wait for ack:
SendToHTTP Follow Redirects:

Time Source

Use NTP:
NTP Hostname:
External Time Source:

DST Settings

Start (week, dow, month):

Start (localtime, e.g. 2h→3h): [hour ↷]
End (week, dow, month):

End (localtime, e.g. 3h→2h): [hour ↶]
DST:

Location Settings

Timezone Offset (UTC +): [minutes]
Latitude: [°]
Longitude: [°]
Note: Longitude and Latitude are used to compute sunrise and sunset

Log Settings

Syslog IP:
Syslog UDP port:
Syslog Log Level:
Syslog Facility:
Serial Log Level:
Web Log Level:

Serial Console Settings

Enable Serial Port Console:
Baud Rate:
Serial Port:
I2C Address:
Channel:
ESP RX GPIO ← TX:
ESP TX GPIO → RX:
Fallback to Serial 0:

Inter-ESPEasy Network

ESPEasy p2p UDP port:

Special and Experimental Settings

Webserver port:
Note: Requires reboot to activate
Fixed IP Octet:
WD I2C Address: (decimal)
I2C ClockStretchLimit: [1/80 usec]
Enable Arduino OTA:
Enable RTOS Multitasking:
JSON bool output without quotes:
Collect Timing Statistics:
Enable RAM Tracker:
Allow TaskValueSet on all plugins:
Check I2C devices when enabled:
Allow OTA without size-check:
Note: When enabled, OTA updating can overwrite the filesystem and settings!
Requires reboot to activate
Web light/dark mode:
Disable Rules auto-completion:
Note: Also disables Rules syntax highlighting!
Disable Save Config as .tar:
Connection Failure Threshold:
Force WiFi B/G:
Restart WiFi Lost Conn:
Force WiFi No Sleep:
Note: Change WiFi sleep settings requires reboot to activate
Periodical send Gratuitous ARP:
CPU Eco Mode:
Note: Node may miss receiving packets with Eco mode enabled
Max WiFi TX Power: [dBm]
Note: Current max: 13.00 dBm
WiFi Sensitivity Margin: [dB]
Note: Adjust TX power to target the AP with (sensitivity + margin) dBm signal strength. Current sensitivity: -72.00 dBm
Send With Max TX Power:
Extra WiFi scan loops:
Note: Number of extra times to scan all channels to have higher chance of finding the desired AP
Use Last Connected AP from RTC:
Enable SDK WiFi Auto Reconnect:
Hidden SSID Slow Connect:
Note: Required for some AP brands like Mikrotik to connect to hidden SSID
Passive WiFi Scan:
Note: Passive scan listens for WiFi beacons, Active scan probes for AP. Passive scan is typically faster.